SECURITY SYSTEM

 

NOTE: It is your responsibility to verify each and every wire. Always take precautions when probing wires so that sensitive components will not be damaged. I assume no responsibility with regards to the accuracy of this information.

 

  1. Wiring an new alarm system to your vehicle
  2. Factory Shock Sensor
  3. Factory Theft Deterrent Relay

 

 

WIRING INFORMATION FOR ALARMS - 2000 PONTIAC GRAND PRIX
ITEM
WIRE COLOR
POL
WIRE LOCATION
12V
Red
+
Ignition Harness
Starter
Yellow
+
Ignition Harness
Ignition
Pink
+
Ignition Harness
Second Ignition
White
+
Ignition Harness
Accessory
Orange
+
Ignition Harness
Power Lock
Lt. Blue
-
Driver Kick Panel
Power Unlock
White
-
Driver Kick Panel
Parking Lights
Brown
+
At the Switch
Headlights
Yellow
+
At the Switch
Door Trigger
Tan and Dk. Blue
-
*1
Trunk / Hatch Pin
Red/ Black
-
Under Rear Deck
Trunk Release
Black / White
+
At the Switch
Factory Alarm Arm
Arms on Lock *3
-
Driver Kick Panel
Factory Alarm Disarm
Orange / Black
-
DKP 32 Pin Plug - Pin 5
Tachometer
Purple / White
ECM Under Hood
Speed Sense
Dk. Green
4
*3
Brake Wire
White
+
Stop Light Switch
Horn Trigger
Black
-
Steering Column
Wipers
Gray
+
Steering Column
LF Window UP / DWN
Dk. Blue - Brown
A
LF Window Motor in Door
RF Window UP / DWN
Lt. Blue - Tan
A
Driver Kick Panel
LR Window UP / DWN
Dk. Green - Purple
A
Driver Kick Panel
RR Window UP / DWN
Lt. Green - Purple
A
Driver Kick Panel
NOTES
This vehicle is equipped with the pass-key III immobilizer. You must use DEI part number 555U to bypass it during remote start mode.
*1
The tan wire is located in the driver's kick and operates only the driver's door. The Dk.Blue is located in the passenger's kick panel and operates all other doors. You must use a diode to isolate these wires
*2
The door trigger must be active to allow the factory alarm to arm
*3
Located at the 10 pin plug on the front of the driver's strut tower. There are two Dk.Green wires there, use the one in the corner of the plug.

 

Factory Shock Sensor - black connector
Pin
Wire Color
Function
A
ORANGE
Fuse Output - Battery
B
YELLOW
Tamper Signal
C
BLACK
Ground
D
--
Not Used

 

Factory Theft Deterrent Relay- gray connector
Pin
Wire Color
Function
A1
WHITE
Headlamp Feed
A2
ORANGE
Fused Battery Feed
B1-B2
--
Not Used
C1
YELLOW
Headlamp Switch Output
C2
ORANGE
Fused Battery Feed